|December 4, 2008 - Time to do a test-fit of the suspension.|
In order to get it in approximately the right place, I'm going to set the lower control arm up so a line drawn between the inner and outer pivot points is horizontal. Most people try to set the arm horizontal, but it's the pivot points that matter. So step 1 is to figure out how high they should be off the ground.
I attached an upright to a wheel and measured the distance from the ground (approximately 8.5"), then figured out how high the car was jacked up (10" above normal ride height). So I want my pivot points 18.5" above the garage floor.