|December 16, 2010 - I've been out of town for over a week, so the MG hasn't seen much action.|
But the whole time I was gone, I was thinking about the fact that my new front fenders should be arriving. Less than 24 hours after getting home, I had the new fenders cut up and was doing test fitting.
And here's where I ran into a problem. Cars taper. They tend to be wider in the middle than the ends. Both the Rabbit and the MGB are like this. So the flares are slightly tapered to match. In the rear, I used the rear fenders on their intended sides and so the taper worked out well. But in the front, I had to flip the fender pieces - from a rear Rabbit fender - to the other side if I wanted the taper to work with me. Unfortunately, no matter how I played with them, I just couldn't get them to sit well on the original wheel cutout.
By flipping them back again - left fender on the left side - I was able to get the shape I wanted with a delicious little curl where the flare melts into the body of the car. That's a great detail on the original Rabbit that you can see with the bumpers pulled. But it meant that the flare was tapered the wrong way. The front of the wheel is left more exposed and there's a bit more flare on the trailing edge. Still, I thought it worked pretty well, so that's what I've done. We'll see what I think when it's all painted up and finished.
I did do a lot more trimming on the metal to deal with this and to mold the flares to the body. I usually find tin snips to be terribly frustrating devices but this turned out to be their destined use. A nice change from noisy power tools that are always trying to fling incandescent metal into my eyeballs.
tags: fenders, body