Slow Car Fast
Click to see the next entry
August 29, 2010 - It's almost time to put the engine in.
But first, I need to get at the slave cylinder. See, the Camaro uses a sealed hydraulic system and I need to mate it to the MG (or a different) master cylinder. It's also hard to bleed the system with the transmission mounted in a small car, or at least that's the fear. So I used the same setup that Flyin' Miata uses in their V8 Miatas. It's a new braided line with a banjo fitting on the end and a second long hose with a cap on it, used for bleeding. Easy enough - but I had to split the engine and transmission to do it.
The T56 transmission is a heavy beast, about 140 lbs. So I used a pair of jacks to hold it level as I pulled it free from the engine. And here's the first surprise - a Spec clutch. Normally, the smart thing to do when you've got your engine and transmission cracked apart is to put in a new clutch, but this one felt pretty good in the Camaro. So it's going to stay.
I thought there had been a change in slave cylinder designs, so I had a new one of the latest design ready to pop in. Well, turns out this car had the same design. It may have dated from the installation of the Spec clutch (remember, this engine was rebuilt about 30,000 miles ago) but whatever the reason, I may not have needed that new slave. Oh well, in it goes.
With the two-jack technique, the transmission slipped right on to the engine smooth as silk. It's never that easy. Which means something must have gone wrong.
tags: transmission